Ender 5 Plus rear electronics case relocation

Mountings bracket to relocate the stock electronics enclosure on an Ender 5 plus to the rear of the machine outside the frame. This re uses the stock bolts that held the enclosure in the frame and M4 bolts and T nuts to mount the brackets to the rear extrusions. I also Cut a hole in the electronics case for the hot bet wiring and the z stepper motor cables to be run out the bottom. The mounts are spaced to provide about the same spacing as the fans would have with the electronics enclosure in the stock location on a table ect. Planning on printing a new enclosure eventually with the fans on the outside plate of the enclosure.