Thingiverse
Ender 5 Plus Simple Split Fan Duct with BL Touch
door Jamesh7897
37
Downloads
17
Likes
2
Makes
This is a Remix
I wanted to keep the hot end as close to stock as possible.
Purpose or this remix to address issues that I had:
1. Did not accommodate for the stock BL Touch bracket that mounts BEHIND the fan assembly.
2. No cable strain relief for the hot end wires.
3. Use of push clip-in nodes to hold the 5015 fan. I added the appropriate spacer to stop vibration, and added through and through holes for bolted on mounting.
4. Put an access hole for tools to reach the upper mounting screw to attach the fan base to the gantry plate ( located right below the upper left fan screw hole). It is tight but any larger would compromise the duct. You can still use the original screws that came with your Ender 5 plus.
*Both Fan arm, and strain relief were epoxied to the fan base.
I wanted to keep the hot end as close to stock as possible.
Purpose or this remix to address issues that I had:
1. Did not accommodate for the stock BL Touch bracket that mounts BEHIND the fan assembly.
2. No cable strain relief for the hot end wires.
3. Use of push clip-in nodes to hold the 5015 fan. I added the appropriate spacer to stop vibration, and added through and through holes for bolted on mounting.
4. Put an access hole for tools to reach the upper mounting screw to attach the fan base to the gantry plate ( located right below the upper left fan screw hole). It is tight but any larger would compromise the duct. You can still use the original screws that came with your Ender 5 plus.
*Both Fan arm, and strain relief were epoxied to the fan base.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!