Thingiverse
Ender 5 Plus TFT35 v1.2 Case Mount
von Access3Dservices
31
Downloads
8
Likes
0
Makes
This two piece set allows a BigTreeTech TFT35 v1.2 screen to be mounted in the stock Ender 5 Plus case and still allows access to the SD card slot in the screen. The case mount adapter is a snap fit into the Ender 5 case and the screen is sandwiched between the two parts with a M3 screw and brass heat set insert.
I'm using it with a Bigtreetech SKR v1.3 board mounted with the simple adapter so it will definitely fit in the Ender 5 Plus case as you can see from the pictures. As far as I know the Ender 5 uses the same case and screen so it should work on that too and maybe other Creality printers as well.
I'm using it with a Bigtreetech SKR v1.3 board mounted with the simple adapter so it will definitely fit in the Ender 5 Plus case as you can see from the pictures. As far as I know the Ender 5 uses the same case and screen so it should work on that too and maybe other Creality printers as well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
