Thingiverse
Ender 5 pro light bars 45 degrees
von Chris_PL
35
Downloads
20
Likes
0
Makes
I do light bars for Ender 5 Pro.
I used two switches, one for the top one, the other for the side ones.
it is powered from printer power supply: 24V. Strip is for 12V are connected in pairs in series, each piece is 15 cm long.
The design is for small switches with a 8x14mm hole
I used two switches, one for the top one, the other for the side ones.
it is powered from printer power supply: 24V. Strip is for 12V are connected in pairs in series, each piece is 15 cm long.
The design is for small switches with a 8x14mm hole
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!