Ender 5 Spool Holder

I created a shim to level out the spool holder for a stock Ender 5. Added a slight lip on it to prevent the updated Spool holder from sliding off.
Modified the updated spool holder to allow it to slide over the existing holder (the inner hole was too small, and I do not want to begin modifying the factory part).
Printing information:
Layer Height: 1.6mm
Infill: 10%
Brim: 20 Lines
Shell Thickness: 1.2mm
Media: PLA

Note: The lip on the shims go toward the outer end of the factory holder. This lip is a snug fir when the printed spool holder over it. This will prevent it from coming off easily, once installed.