Ender 5 X-axis motor mount

To raise the X axis in ender 5 and related printers.
Raising the X axis by 20mm allows you to increase the working area in the X axis to 245mm (over the size of the table, so the bltouch can sample the entire table)
Lifting the axis is simple - just screw the X-axis 2020 aluminum beam to the trolleys with longer screws (M5 x 40) and place between the trolley and the beam - pieces of the 2020 profile, about 3-4 cm (which will guarantee symmetrical lifting on both sides by the thickness of the 2020 profile, i.e. 20mm).
Unfortunately, after such a lifting - the toothed belt would not hit the profile, so you also have to lift the X-axis motor.

Disassemble the X axis motor, install this distance in its place, and screw the motor through it, from above (instead of from below). You still need to change 2 (out of 4) wires with each other, or change the direction of the X axis in the firmware so that the motor rotates in the opposite direction (when turned upside down, it must also turn i