Thingiverse
ENDER 6 DOOR HINGE
por saturn_frak
0
Descargas
1
Likes
0
Makes
A remix with much tighter design (7mm width instead of 10mm) considering the 5mm door width it holding better
Pay attention that for this replacement to work well it's neccessery to cut ~1mm into the door so it'll close well in the middle
v3 - already removed the extra that block the acrilic door to get till the end + moved the hole for the metal rode towards the edge + reduced the holding width
Added also a frame mount as the original one doesn't fit (the screw holes)
Frame mount v2 had bigger holding hook - much stonger to hold the pin and not break
Pay attention that for this replacement to work well it's neccessery to cut ~1mm into the door so it'll close well in the middle
v3 - already removed the extra that block the acrilic door to get till the end + moved the hole for the metal rode towards the edge + reduced the holding width
Added also a frame mount as the original one doesn't fit (the screw holes)
Frame mount v2 had bigger holding hook - much stonger to hold the pin and not break
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!