Ender 7, klicky probe

# Ender 7 Klicky Z probe

You will need to be running klipper (see the config files, your park position will be around 5mm further on the X than mine - I broke my X endstop and replaced it with a larger one, so I lose about 5mm on X)
Uses 5mm by 1.5mm magnets (6), magnets are either press fit or super glued (press is better as the glue can effect the electrical contact)
The microswitch is NC (normally closed) - so can be wired in series with the existing endstop.
The dock mounts on the right pillar and is adjustable (up and down), when mounting the dock:
* move the gantry by hand to get the dock hieght adjustment correct.
* Adjust the height on the pillar so the probe lifts slightly to make contact with the probe mount (this helps it overcome the magnetic force of the pillar as it moves away).
* The probe can either be wired in series with the existing end stop or completely replace it.
* When working out the dock position - before updating the klipper config home your z axis