Thingiverse
Ender Bed Buffers
von letscho2k
4
Downloads
5
Likes
0
Makes
Those bed leveling buffers are doing a really good job since I'm using them.
The bad news is that they will not work when printed in PLA - you have to get started printing with TPU!
You will need:
3 18mm buffers (40% infill)
1 16mm buffer (40% infill)
1 3mm Allen key
Installation is straight forward - take all four leveling screws off lift the bed & replace the springs with buffers (small one goes in the corner with the cable).
The tricky part is that the Z-stop will now be offset & you need to loosen the two Allen screws and adjust to the new Z=0.
Your leveling will now be a lot more firm.
The bad news is that they will not work when printed in PLA - you have to get started printing with TPU!
You will need:
3 18mm buffers (40% infill)
1 16mm buffer (40% infill)
1 3mm Allen key
Installation is straight forward - take all four leveling screws off lift the bed & replace the springs with buffers (small one goes in the corner with the cable).
The tricky part is that the Z-stop will now be offset & you need to loosen the two Allen screws and adjust to the new Z=0.
Your leveling will now be a lot more firm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!