Ender Direct Drive Light (EDL)

Design is similar to xLORDxSIDIUSx thing 3734379.
EDL is longer so that the motor can be on the back side.
Added a side x-bar for stability.
EDL is compatible with my cooling system Hush!
https://www.thingiverse.com/thing:4642521

Compared to other Direct Drive solutions:
No compression fittings
Light
Simple
Easy and fast to print
No supports
No extra plastic between motor and BMG. That saves 2-3mm of motor length*
Motor can be oriented above X gantry for best point of gravity.
No plastic around motor helps with cooling.

X-bar:
Add stability.
Take some of the load from the heatsink.
Prevent the shaft to unscrew itself.
Has line at 10 degrees so that the motor can be oriented in the optimal direction*
Function as a handgrip when the PTFE tube is compressed

Shaft:
There are two versions. One for Dotbit and one for BMG (not tested).
Only tighten it lightly with your hands. It snaps of if you tighten it too hard.

Tube cutter(for Dotbit):
Use included tub cut