Thingiverse
Ender Extruder Face Upgrade
5
Downloads
6
Likes
0
Makes
Want to put a face on your print head? :D
I've provided two versions, one with and one without holes for the eyes, depending on what type of googly eyes you have available.
Personally, I prefer the plastic type that you use for toys. The ones I used are 14.8mm in diameter - see attached. You can get them from any craft shop or eBay for a couple of quid/dollars.
Or, if you just have the stick on ones, then go for the "no holes" version.
The eyebrows are separate, it's much easier just to stick them on with glue than mess about with supports, also makes it easier if you want to do different colours. They are a bit fiddly though!
It doesn't have any mounting options, I've just stuck mine on with bluetack for now.
I've provided two versions, one with and one without holes for the eyes, depending on what type of googly eyes you have available.
Personally, I prefer the plastic type that you use for toys. The ones I used are 14.8mm in diameter - see attached. You can get them from any craft shop or eBay for a couple of quid/dollars.
Or, if you just have the stick on ones, then go for the "no holes" version.
The eyebrows are separate, it's much easier just to stick them on with glue than mess about with supports, also makes it easier if you want to do different colours. They are a bit fiddly though!
It doesn't have any mounting options, I've just stuck mine on with bluetack for now.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!