Thingiverse
Ender Filament Guide
door axerae
1
Downloads
14
Likes
0
Makes
Made a long neck and base with 20mm pitch for Ender V2 and Ender V3 KE. There two bores on each side for a 3mm heated threaded insert for filament runout sensors (especially stock KE).
After I wall mounted my filament spools (because of shaking), I took off the stock holder and replaced with this guide. You can use the threaded holes on the KE or T-nuts on the V2. This will work in any extrusion frame with the correct t-nuts or other printers with a 20mm pitch between fasteners. I printed this in PETG
Remixed version of tommytwothousand's filament guide: https://www.thingiverse.com/thing:2163508
After I wall mounted my filament spools (because of shaking), I took off the stock holder and replaced with this guide. You can use the threaded holes on the KE or T-nuts on the V2. This will work in any extrusion frame with the correct t-nuts or other printers with a 20mm pitch between fasteners. I printed this in PETG
Remixed version of tommytwothousand's filament guide: https://www.thingiverse.com/thing:2163508
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
