Thingiverse
Ender Jet Cooling Duct
door hansvanlin
21
Downloads
6
Likes
0
Makes
Simple Low profile cooling upgrade.
Optimized the airflow to the printed part.
The .3 version is nice in combination with the Dragon Fly bms hotend.
The .4-GapFix version is 1mm further from the heatbed. (updated after tip that there was a gap)
The bridge test is done with PETG at 50mm/s LH=0.2mm,0.65with Fan at 75%, without the special Cura settings for bridging.
Bridge test: https://www.thingiverse.com/thing:476845
https://youtu.be/5g5ITad61xc
Optimized the airflow to the printed part.
The .3 version is nice in combination with the Dragon Fly bms hotend.
The .4-GapFix version is 1mm further from the heatbed. (updated after tip that there was a gap)
The bridge test is done with PETG at 50mm/s LH=0.2mm,0.65with Fan at 75%, without the special Cura settings for bridging.
Bridge test: https://www.thingiverse.com/thing:476845
https://youtu.be/5g5ITad61xc
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
