Ender2 Pro LED Bar

Ender-2 Pro LED Bracket Braket to hold a LED bar on the Creality Ender 2 pro Versions This comes in a M3 or M4 Bolt version. (M3 Pictured) Parts / Assembly M3 x 12mm Nuts (4) M3 x 12mm Screws (4) 4 T-Nuts (I printeed these M3 TNUT holders) 10 - 12 inches of LED Diffuser Wire 24 / 12 V LEDs 12V Buck converter (optional) The Ender 2 Pro runs on 12 volts, where as many LED strips run on 12V. If using 12V leds, add a 12V buck converter or DC-DC Converter. This one should be fine for up to 1Amp of current (Add a heatsync if planning on using more than 1Amp). You will need to splice in power from the 24V output of the circuit board. For safety, it is reccomended toNOT add tinned wire to the wires that will be crimped in the screw terminal. The best connection will be with a Ferrule Crimping Tool. Links *Github: https://github.com/spuder/ender2pro-led-bracket Resources LED Diffuser JST Connector 12 V Buck Converter Ender 2 Pro T-Nuts Ferrule Crimping Tool Category: 3D Printer Accessories