Thingiverse
Ender3 Auto power off V2
by hr_l0ve
434
Downloads
355
Likes
0
Makes
Ender3 Auto Power Off
switch size:
14mm * 8.5mm
・It can be attached and detached without using tools. (Slide while pulling)Detachable while driving.
・When installing for the first time, it is recommended to adjust the screws to fit the modeled object and ender 3.
・If you turn it over, you can attach it in the opposite direction.
Update V2 !!
june 16, 2021 17:00(UTC+0900)
・No need for support. (Only when using 0.12 mm layer height, adaptive layers or gcode files)
・To prevent damaging the printer add
Preferences → printer → Printer settings → End G-Codes:
M104 S0; Set Hot-end to 0C
G4 S90 ; Wait 90 seconds to cool down
Place it in front of [ G1 X0 Y235 ;Present print ] or [ G1 X0 Y{machine_depth} ;Present print ], depending on the software you are using
・I made it because I wanted to make a switch that can be attached and detached without using tools.
switch size:
14mm * 8.5mm
・It can be attached and detached without using tools. (Slide while pulling)Detachable while driving.
・When installing for the first time, it is recommended to adjust the screws to fit the modeled object and ender 3.
・If you turn it over, you can attach it in the opposite direction.
Update V2 !!
june 16, 2021 17:00(UTC+0900)
・No need for support. (Only when using 0.12 mm layer height, adaptive layers or gcode files)
・To prevent damaging the printer add
Preferences → printer → Printer settings → End G-Codes:
M104 S0; Set Hot-end to 0C
G4 S90 ; Wait 90 seconds to cool down
Place it in front of [ G1 X0 Y235 ;Present print ] or [ G1 X0 Y{machine_depth} ;Present print ], depending on the software you are using
・I made it because I wanted to make a switch that can be attached and detached without using tools.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
