Ender3 Board Cover
von 419mining
20
Downloads
11
Likes
0
Makes
updated Creality Ender 3 main board cover. This one is setup for the stock 40mm fan to be mounted in from below. using M3 12mm screws. The cover is 3mm thick to match the SDcard front cover. https://www.thingiverse.com/thing:3455823
after upgrading the main board to v1.1.5 and adding a buck converter for 12v fans, the case cover was way to tight, this brings the roof up 10 mm, and vents the heat out the back.
**Print upside down (fan facing the build plate)** with supports from the buildplate only.
20% infill works fine if you dont crush the screws in.
after upgrading the main board to v1.1.5 and adding a buck converter for 12v fans, the case cover was way to tight, this brings the roof up 10 mm, and vents the heat out the back.
**Print upside down (fan facing the build plate)** with supports from the buildplate only.
20% infill works fine if you dont crush the screws in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
