Thingiverse
Ender3 Camera holder
von goliaz23
269
Downloads
140
Likes
0
Makes
I was looking for a few things for my camera mount:
- Close enough to the print to be able to distinguish the details
- To go up with the print head
- Robust enough not to vibrate and blur the image
- Easy to install without screws or accessories.
I found the design of [lab27](https://www.thingiverse.com/lab27) to be very good for that, so I modified it a bit to work with the Ender3 and to simply snap into place onto the cover of the X axis pulley.
The camera case works for the standart size camera (~24*25mm with 4 mounting holes 20mm appart in width and 12mm in height)
- Close enough to the print to be able to distinguish the details
- To go up with the print head
- Robust enough not to vibrate and blur the image
- Easy to install without screws or accessories.
I found the design of [lab27](https://www.thingiverse.com/lab27) to be very good for that, so I modified it a bit to work with the Ender3 and to simply snap into place onto the cover of the X axis pulley.
The camera case works for the standart size camera (~24*25mm with 4 mounting holes 20mm appart in width and 12mm in height)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
