Thingiverse
Ender3 Pro Y Axis End Stop
door Cl1ff0rd
1
Downloads
0
Likes
0
Makes
I found my Ender 3 Pro would home too far in front of the build plate, so i made this in Tinkercad to bring the switch forward a bit
I used petg on my CR6SE but the 6se wasnt in the drop down selections, PLA would be just as good i just used what was set up already
The only other thing you need are 2 x m4 hex nuts, i used 6.5mm
I used petg on my CR6SE but the 6se wasnt in the drop down selections, PLA would be just as good i just used what was set up already
The only other thing you need are 2 x m4 hex nuts, i used 6.5mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!