Thingiverse
Ender3 V2 and S1
door FrankPhrankly
4
Downloads
4
Likes
0
Makes
If you get the 4 linear rail upgrade from EBAY for the Ender3 Pro and plan to use on Ender3 V2 or S1, these are some things to print up before you begin. If you have direct feed you should figure that out ahead of time as well.
For the Y axis switch there is nothing to hit switch after upgrade, this bracket will work and is adjustable.
The X axis switch is also misaligned after upgrade and this new cover move switch out and to the right so it lines up.
The spacer is for the X axis belt tensioner. A bracket is removed leaving the rear mount hanging in the air. Use spacer so you can tighten rear screw.
For the Y axis switch there is nothing to hit switch after upgrade, this bracket will work and is adjustable.
The X axis switch is also misaligned after upgrade and this new cover move switch out and to the right so it lines up.
The spacer is for the X axis belt tensioner. A bracket is removed leaving the rear mount hanging in the air. Use spacer so you can tighten rear screw.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!