Thingiverse
Ender3X bed leveling adapter
door jpnurro
0
Downloads
5
Likes
0
Makes
The Ender3X comes with two printing surfaces, the standard and glass .
When you'd like to use the other you'll need to re-calibrate the bed height because the glass surface is 2.2mm thicker - until now!
Here's shim plate allowing the quick swap.
Adjust the bed height with the standard surface. When you like to use glass bed place the shim on the Z-microswich.
The thickness difference of the surfaces is the same as a SDCard. Sand the shim's longer (top) section even with the SDCard and you are a quite right.
Please, check that the adapter allows free movement of the microswich.
When you'd like to use the other you'll need to re-calibrate the bed height because the glass surface is 2.2mm thicker - until now!
Here's shim plate allowing the quick swap.
Adjust the bed height with the standard surface. When you like to use glass bed place the shim on the Z-microswich.
The thickness difference of the surfaces is the same as a SDCard. Sand the shim's longer (top) section even with the SDCard and you are a quite right.
Please, check that the adapter allows free movement of the microswich.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
