Ender5Plus Corexy Conversion Enclosure Lid

UPDATE 07/01/2022
Refer to the Electronix Case for acrylic panels, associated mounts and BOM.
https://www.thingiverse.com/thing:5110697

---

UPDATE 07/01/2022
The small printable panels to fit each end of the rear frame replace the acrylic. I found that it's better to have them on each side. The fans can be controled by the control board with a enclosure thermister (if you have enough outlets/pins on the control board).

---

UPDATE 17/12/2021
Passive chamber temps just from the heated bed were climbing over 45°C so I have added a printable extractor panel to mount a 6010 fan and carbon filter.
Fan requires 4x M4 BHCS and 4x M4 nuts. This can be mounted on either side of the lid frame replacing the small acrylic panel. Fan wire and 2pin jst plug has been accommodated for to keep wiring tidy.

Find a local supplier of aquatic carbon filters and cut to suit holder. Holds 20mm thick filters.

Please also note this lid enclosure is intended to fit my corexy convers