Ender5Plus Filament Guide

Not really a remake, but I stole the idea.

I reworked because I have my filament spool on the left side. It's now easier to have a longer bowdentube. I added a little guide for that on the end. And also the tie-wraps I use are much smaller, so the whole guide for the tube could be less wide.

I also dislike the tube so close top the filament sensor. It's not very handy if you change filament a lot. So I made a little gap, so there is about 1 cm of filament visible and easy to line it up in the sensor's hole.