Thingiverse
Endstop Switch Mount on Rod
von Froggysoft
22
Downloads
16
Likes
0
Makes
A simple Endstop Switch Mount:
- Height is switchblock height plus connector height, so those are nicely hidden.
Parameters
- Rod-diameter: I've added 8, 10 and 12 mm STLs
- Wall thickness: for a 8mm rod a 4mm wall thickness might look a bit bulky, for 12mm rod a 4mm wall look just right
- Clamp bolt length, I've set 13mm so the head and nut are sunken
- Height is switchblock height plus connector height, so those are nicely hidden.
Parameters
- Rod-diameter: I've added 8, 10 and 12 mm STLs
- Wall thickness: for a 8mm rod a 4mm wall thickness might look a bit bulky, for 12mm rod a 4mm wall look just right
- Clamp bolt length, I've set 13mm so the head and nut are sunken
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!