Epoxy Mixer

UPDATE: The magnet did not work because of the metal screw holding the cup holder on the motor. I had to cut a piece of 1/4" stainless rod about 3/4" long and super glue a bent wire to the top. Works 4.0.

The cup holder on this mixer is for the smaller cups. I put none slip tape around the lip to help stabilize/prevent the cup from turning in the holder. The motor is from Ebay (https://www.ebay.com/itm/124840891278). Any single pole switch will work. I got these small ones from Ebay years ago and could not find them in my history, but it doesn’t matter. I did not place a hole for the switch so no matter what you choose, just drill a hole where it will fit. I also finished up the bottom with none stick tape which I purchased years ago when I was flying drones. I included a picture of the bag in the description. The center of the motor shaft takes a 3mm screw...I think. I plan on using one of these magnets to drop in the epoxy as an agitator: https://www.ebay.com/itm/36581