Thingiverse
Epoxy stirer
von Robdoc
12
Downloads
15
Likes
0
Makes
Non-printed tools I used:
https://www.amazon.com/gp/product/B07HJ33DYK/
https://www.amazon.com/gp/product/B00HP8SUUM/
Some screws I picked up from wal-mart. 4 x 1/2".
2oz "Bank sinkers" to do the actual stiring
Make sure to use a counterweight if you aren't using an even number of holes.
I had to sand down the bottom of the shaft on the turner section a few mm in order to get the holes for the stopper to line up.
Be careful removing the supports around the shaft.
V9 adds two more cups and the cups are deeper.
gif of model https://imgur.com/dyYwqEI
gif of turner moving https://imgur.com/agzlqi8
https://www.amazon.com/gp/product/B07HJ33DYK/
https://www.amazon.com/gp/product/B00HP8SUUM/
Some screws I picked up from wal-mart. 4 x 1/2".
2oz "Bank sinkers" to do the actual stiring
Make sure to use a counterweight if you aren't using an even number of holes.
I had to sand down the bottom of the shaft on the turner section a few mm in order to get the holes for the stopper to line up.
Be careful removing the supports around the shaft.
V9 adds two more cups and the cups are deeper.
gif of model https://imgur.com/dyYwqEI
gif of turner moving https://imgur.com/agzlqi8
Robdoc veröffentlicht auch auf
11 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
