Thingiverse
EQ5 EOS Dummy Batterie Holder
door Astrolab_Service
11
Downloads
12
Likes
0
Makes
Hello everyone,
This design is a holder for dummy batterie for EOS DSLR (550D, 600D, 700D, Rebel T2i, Rebel T3i, Rebel T5i). It is made for Skywatcher EQ5 tripod (44 mm) and use M4 nuts.
I wanted originaly to do a holder for a Celestron CGX tripod (51 mm). This is why it has been printed with silk copper PLA to match the Celestron / CGX look. By mistake I used a wrong template, used from an old EQ5 tripod project. Of course 44 mm doesn't fit with 51 mm... Instead of trashing the stl file, I decided to share it.
The correct CGX holder can be found here:
https://www.thingiverse.com/thing:4921934
My 3D Printer is a Anycubic i3 Mega. Eventually you need to widen stuff, depending on your own printer tolerances. At least it gives you some insperations to make your own.
This design is a holder for dummy batterie for EOS DSLR (550D, 600D, 700D, Rebel T2i, Rebel T3i, Rebel T5i). It is made for Skywatcher EQ5 tripod (44 mm) and use M4 nuts.
I wanted originaly to do a holder for a Celestron CGX tripod (51 mm). This is why it has been printed with silk copper PLA to match the Celestron / CGX look. By mistake I used a wrong template, used from an old EQ5 tripod project. Of course 44 mm doesn't fit with 51 mm... Instead of trashing the stl file, I decided to share it.
The correct CGX holder can be found here:
https://www.thingiverse.com/thing:4921934
My 3D Printer is a Anycubic i3 Mega. Eventually you need to widen stuff, depending on your own printer tolerances. At least it gives you some insperations to make your own.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
