Ergo Mouse Shape using G305 PCB

This is my design for an ergonomic mouse shape using the Logitech G305 PCB.

As this was my first attempt at designing something for 3D printing, the actual files I printed (Top and Base) are not perfect and some sanding is required to make all the components fit. Mainly, I found parts of the Top had to be sanded down to fit the PCB in. I also had to sand down the back of the on/off switch taken from the G305, as it was too tall and pushed up against the PCB (this didn't affect the usability of the on/off switch at all).

I also de-soldered the M1 and M2 mouse switches from their individual PCBs, superglued them directly onto the main PCB, and soldered the wires directly to the pins under the mouse switch (I believe the red wire should be soldered to the M1 middle pin, the white wire to the M2 middle pin, and the corresponding black wires to the front pins). Personally, I had to make the M1 and M2 button pressers on the top shell longer (I used tiny squares of electrical tape and a