Thingiverse
Ergonomic Ring Pen
por CourageKenny
6
Descargas
27
Likes
1
Makes
This is not a remix, but was inspired by the "Finger Loop Hobby Knife" found on Printables.com. Similar concept with basic finger loop "ring" to help stabilize a short "bic" pen. It may be beneficial for some with limited dexterity or finger discomfort.
Parts required:
Bic Round Stick M pen
Tools Required:
Side Cutter Tool
Print Profile:
15% Infill
PLA
Print as oriented (circle/ring in full contact with build plate)
Should not require brim, but may depend on your printer/settings
No Support
Assembly (see pictures)
Make cut on Pen's shaft just after the "m". Length of shaft should = 44 mm
Cut Ink Tube so the length from ballpoint tip to end of ink tube = 60mm
Optional - Superglue the the ballpoint to the outer shaft tube to keep it from pulling out when flipping pen to cap it
Parts required:
Bic Round Stick M pen
Tools Required:
Side Cutter Tool
Print Profile:
15% Infill
PLA
Print as oriented (circle/ring in full contact with build plate)
Should not require brim, but may depend on your printer/settings
No Support
Assembly (see pictures)
Make cut on Pen's shaft just after the "m". Length of shaft should = 44 mm
Cut Ink Tube so the length from ballpoint tip to end of ink tube = 60mm
Optional - Superglue the the ballpoint to the outer shaft tube to keep it from pulling out when flipping pen to cap it
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
