Thingiverse
ESC Wire Brace / Holder
von BADbloodBEAR
50
Downloads
40
Likes
0
Makes
Snaps on over the aluminum center brace of all ARRMA 1/7 scale vehicles to allow for bracing of the three esc to motor signal wires to keep them organized, prevent the wear from movement, and can help keep them out of the drivetrain components.
Print:
PLA
0.1-0.3mm @ min 40% infill
Requires:
3x M3 screws (6-12mm)
Print:
PLA
0.1-0.3mm @ min 40% infill
Requires:
3x M3 screws (6-12mm)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
