Thingiverse
ESP 01 Connector
von NirDobovizki
42
Downloads
20
Likes
0
Makes
The ESP 01 Board (based on the ESP 8266) is tiny and cheap and a really good way to add WiFi capabilities to your project, however, it is also not solderless-breadboard friendly.
This is a small connector that fits the ESP 01 board and is easy to connect.
The smaller part is the top, insert your wires into the little grooves at the top, then press the ESP01 into the holes on top of them.
You can use the connector standalone when you just need the ESP 01 or you can use it as a part of a bigger project.
The top is designed to fit into a hole in a lid of a box, the narrower part fits into the hole and the lid covers the wider part and holds the wires in place.
I've included the SkethUp file so you can easily use it in your own designs.
Designed with SketchUp, STL cleaned with Microsoft 3D Builder, sliced with Cura and printed on my Robo3D R1+
This is a small connector that fits the ESP 01 board and is easy to connect.
The smaller part is the top, insert your wires into the little grooves at the top, then press the ESP01 into the holes on top of them.
You can use the connector standalone when you just need the ESP 01 or you can use it as a part of a bigger project.
The top is designed to fit into a hole in a lid of a box, the narrower part fits into the hole and the lid covers the wider part and holds the wires in place.
I've included the SkethUp file so you can easily use it in your own designs.
Designed with SketchUp, STL cleaned with Microsoft 3D Builder, sliced with Cura and printed on my Robo3D R1+
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
