Thingiverse
ESP-01 electronics box
door R0peE
6
Downloads
6
Likes
0
Makes
A nice electronics box for the ESP-01 wifi module with 5v-3.3v adapter. Original design can be found here: https://www.thingiverse.com/thing:3472764
Assembly:
- The box is snap fit, not too tight, but depends if you have calibrated your e-steps :)
- 2 or 4 M2x8 screws are required to hold the board in place
- On the side holes M3 screws can be used in the required length to attach the box. The head of the screw should be inside the box, and can be turned from the opposite hole with an allen key or small screwdriver
Assembly:
- The box is snap fit, not too tight, but depends if you have calibrated your e-steps :)
- 2 or 4 M2x8 screws are required to hold the board in place
- On the side holes M3 screws can be used in the required length to attach the box. The head of the screw should be inside the box, and can be turned from the opposite hole with an allen key or small screwdriver
R0peE publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
