Thingiverse
ESP-01 Helper box
von stefan63
1
Downloads
0
Likes
0
Makes
Box to support USB-UART on the ESP-01 Helper that I bought from ebay.
I have no relations to the ebay seller but like his little ESP-01 helper.
I made this "lower box" to make my unit last longer, its a very simple design so I used
hot glue to mount the uart board and cyanoacrylate glue "crazy glue" to mount the esp-01 helper to the edge of the box.
Other fun stuff at my personal website: stockholmviews.com
stl file and f3d is straight from Fusion 360.
I printed mine in .2mm layer height and .4mm whidt and used PLA at 220c no support no brim or skirt and the big flat side agains the bed.
I have no relations to the ebay seller but like his little ESP-01 helper.
I made this "lower box" to make my unit last longer, its a very simple design so I used
hot glue to mount the uart board and cyanoacrylate glue "crazy glue" to mount the esp-01 helper to the edge of the box.
Other fun stuff at my personal website: stockholmviews.com
stl file and f3d is straight from Fusion 360.
I printed mine in .2mm layer height and .4mm whidt and used PLA at 220c no support no brim or skirt and the big flat side agains the bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!