ESP Parametric Case | Magnetic

Fully Parametric ESP32 / ESP8266 Case🔧 FeaturesSnap-fitCustomize- Board width (mm): 20 - 40- Board length (without Antenna) (mm): 40 - 70- Board thickness (mm): 0.8 - 2- Inner box <-> Board dif (mm): 1.5 to 30 1.5 => Header Outside 7.5 => Header Inside- Additional box length (mm): 0 - 30 If your board has an antenna, set it at least to 6mm- Additional box width (mm): 0 - 16- Show/Hide header holes: 1=Show; 0=Show- Create two cable holes at the USB side: 1=Show; 0=Hide (only created, if box <> board dif ≥ 8mm)- Create two cable holes at the antenna side: 1=Show; 0=Hide- Cable hole diameter (mm): 2 - 6- Show/Hide sensor holes: 1=Show; 0=Show (only created, if lengthAdd ≥ 14mm)Support:- Square or rounded PCB corners- micro USB or USB-C- Any Pin CountWall Mount - Magnetic: (8x2mm) Just press them into the holes.- Screws: Distance 40mmOpener🖨️ Print SettingsMaterial: PLA or PETGLayer height: 0.2 mmSupports: not neededChange Log2026-01-30 - cableHoleAntennaSide did not work (thanks to @nop