Thingiverse
esp32 and 2 Relay case
door danprogram
333
Downloads
279
Likes
0
Makes
This is an enclosure/box i designed for a garage door opener project. It houses an esp32 and a 2 relay board in as small a box as i could manage and still have it fit nicely. The lid clicks on with a zip tie/cable tie type of mechanism that seems to work well. It is a completed project and source code will be made available on my GitHub page when i get the time to upload it. I left the hole around the esp USB port a little large to make fitting the board in a little easier.
The lid warped some during printing, likely due to heated bed temp being too low.
The lid warped some during printing, likely due to heated bed temp being too low.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
