ESP32 C3 Wake on LAN Button WOL

This is a compact desktop enclosure for an ESP32-C3 Super Mini that sends a Wake-on-LAN magic packet over WiFi whenever you press the button. The ESP32 does not need to be connected to your PC at all it just needs power from any USB charger. As long as it is on the same WiFi network as your PC, it will wake it up from anywhere in the room.
**Important: Your PC must be connected to your router via an Ethernet cable for Wake-on-LAN to work. WiFi adapters lose power when the PC is off and cannot receive the magic packet.**
The enclosure is made up of 3 printed parts: top, middle, and bottom.
Assembly:

Before assembling, solder two wires GPIO2 and GND on the ESP32-C3, and connect the other ends to NO (Normally Open) terminal and the Common terminal on the button.
Drop the ESP32-C3 down through the hole in the middle.stl part and seat it into its slot.
Place the button body into its slot in the middle.stl part from above.
Close the bottom of the ESP32 cavity by pressing on the bottom.stl p