Thingiverse
ESP32-CAM Case Housing
0
Downloads
0
Likes
0
Makes
This is a case/housing I designed for the ESP32-CAM. This is NOT designed for the regular serial host board meant for the ESP32-CAM. Those are near impossible to obtain unless you purchase a ESP32-CAM and serial board combo from a site like Amazon etc.
[Here](https://www.inspectmygadgets.com/an-esp32-cam-adaptor-pcb/) is the PCB to order that will fit with the ESP32-CAM in this case. It will need to be ordered from [PCBWay](https://www.pcbway.com/project/shareproject/ESP32_CAM_Adaptor_PCB.html). One thing to note is that the square pin/pad labeled "gnd" is NOT actually a ground, and you need to either remove the corresponding pin from the ESP32 or from the female dupont connector that gets soldered to the board. Failing to do so will prevent the device from booting at all.
This case is designed for use with the ESP32-CAM attached to the above board with two 8-pin female dupont headers and one female mini USB connector installed. It has not been tested with other add-ons suggested
[Here](https://www.inspectmygadgets.com/an-esp32-cam-adaptor-pcb/) is the PCB to order that will fit with the ESP32-CAM in this case. It will need to be ordered from [PCBWay](https://www.pcbway.com/project/shareproject/ESP32_CAM_Adaptor_PCB.html). One thing to note is that the square pin/pad labeled "gnd" is NOT actually a ground, and you need to either remove the corresponding pin from the ESP32 or from the female dupont connector that gets soldered to the board. Failing to do so will prevent the device from booting at all.
This case is designed for use with the ESP32-CAM attached to the above board with two 8-pin female dupont headers and one female mini USB connector installed. It has not been tested with other add-ons suggested
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
