Thingiverse
ESP32-CAM Enclosure
por VaTTeRGeR
201
Descargas
218
Likes
4
Makes
Compact enclosure for the ubiquitous ESP32-CAM with the USB-Serial board and an external antenna. The program- and reset-button are still accessible through the cooling slits.
Update: SD-Card also accesible now!
The holes in the bottom piece are laid out in a 34x21mm rectangle. They are sized for M3-5x5mm threaded inserts.
Use the combined *.stl file for easy printing. Print time is 3 hours with average printing speeds and 100% infill. Support should not be necessary if your cooling is sufficient.
Additional Materials:
1. Glue (Cyanacrylate aka Super Glue is recommended)
2. Optional: Threaded inserts M3-5x5mm
Assembly:
1. Insert the Camera into the front piece, guiding the antenna cable through the small gap on the side of the enclosure.
2. Screw the SMA-Connector to the bottom piece and wind the excess antenna cable into a loop.
3. Test fit the two halves, then glue together with super glue once everything fits. The two halves are self aligning.
4. Melt the thread
Update: SD-Card also accesible now!
The holes in the bottom piece are laid out in a 34x21mm rectangle. They are sized for M3-5x5mm threaded inserts.
Use the combined *.stl file for easy printing. Print time is 3 hours with average printing speeds and 100% infill. Support should not be necessary if your cooling is sufficient.
Additional Materials:
1. Glue (Cyanacrylate aka Super Glue is recommended)
2. Optional: Threaded inserts M3-5x5mm
Assembly:
1. Insert the Camera into the front piece, guiding the antenna cable through the small gap on the side of the enclosure.
2. Screw the SMA-Connector to the bottom piece and wind the excess antenna cable into a loop.
3. Test fit the two halves, then glue together with super glue once everything fits. The two halves are self aligning.
4. Melt the thread
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
