Thingiverse
ESP32 Cam + Neopixel Ring
von soapsrx
24
Downloads
18
Likes
0
Makes
ESP32-Cam with a neopixel ring to illuminate the area. I designed this to monitor my prints using ESPHome & Homeassistant. With this light, I can monitor my prints when the surrounding area is dark.
Things Needed:
Ai-thinker ESP32 cam
16 Led Neopixel Ring
M3 Screws (5mm)
M3 threaded inserts OD- 4mm (Optional)
3.5mm DC male/ female connector
5V Power Supply (Can use buck converter to lower the voltage of printer power supply from 24v to 5v)
Ender 3 Mount Use this mount
Hotglue
Software / Wiring:
ESPhome Config File is Included
Pinout:
Neopixel Data - ESP32cam GPI02 pin
Neopixel GND - ESP32cam GND pin
Neopixel VCC - ESP32cam +5v pin
DC jack +5v - ESP32cam +5 pin
DC jack GND - ESP32cam GND pin
Things Needed:
Ai-thinker ESP32 cam
16 Led Neopixel Ring
M3 Screws (5mm)
M3 threaded inserts OD- 4mm (Optional)
3.5mm DC male/ female connector
5V Power Supply (Can use buck converter to lower the voltage of printer power supply from 24v to 5v)
Ender 3 Mount Use this mount
Hotglue
Software / Wiring:
ESPhome Config File is Included
Pinout:
Neopixel Data - ESP32cam GPI02 pin
Neopixel GND - ESP32cam GND pin
Neopixel VCC - ESP32cam +5v pin
DC jack +5v - ESP32cam +5 pin
DC jack GND - ESP32cam GND pin
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
