ESP32 Rover Kit Case V2

ESP32 Rover Kit Case V2

This case has been designed to house the ESP32-ROVER-KIT and suits the Version 2.
Although this board is quite old now I believe there were a total of 4 revisions of the board.
In developing the case I used a modified Version 4 CAD model of the board.
The major difference between V2 and V4 were switch type changed, micro usb position changed and some headed pins layout changed.

For me the EN Reset switch never worked and I found that R61 was not needed so a tiny dab of conductive paint on the top of R61 shorts it out and the reset then works.

The case clips in place with no need for any screws.

Printed on 0.2mm PLA. I did use supports for the SD Carde hole but this may not be necessary on your printer.

I've included Step files as well as stl's as this will make it easier to make any adaptions you may need.


Hope this helps someone.