MakerWorld
Electronics
Go to Model
ESP32 + w5500 ethernet box
1
Downloads
0
Likes
0
Makes
Simple enclosure to house an ESP32 and a W5500 Ethernet board, with space for connection cables.The box provides room beneath the ESP32 and above the W5500 board for wiring, plus extra space at the back to accommodate jumper wires with male/female connectors — no soldering or custom cables required.Vent holes on the lid and back ensure good airflow.Depending on the material used (PLA/PETG), the lid may fit a bit loosely; in that case, a strip of masking tape can help improve the fit.The llama has been airbrushed and is not included in the print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!