Thingiverse
esp8266 case
von mikbund
15
Downloads
8
Likes
0
Makes
made this basic box in Tinkercad for measuring temperature in my basement. Requires a OLED 0.96" and a DHT22 sensor.
Depending on which ESP8266 nodemcu board you will need to glue the board as well. Some boards are larger than others.
Glue the oled case to the cover and you are good to go.
The OLED case was downloaded from here. http://www.thingiverse.com/thing:1315770
Depending on which ESP8266 nodemcu board you will need to glue the board as well. Some boards are larger than others.
Glue the oled case to the cover and you are good to go.
The OLED case was downloaded from here. http://www.thingiverse.com/thing:1315770
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
