Thingiverse
ESP8266 Enclosure
por jwitting
343
Descargas
249
Likes
0
Makes
I printed the enclosure by jperson thinking it would fit my ESP8266/NodeMCU board but it was apparently designed for a different, larger dev board. The holes for the pins fit perfectly though and I liked the form factor a lot, so I adjusted it to fit my board, which just required moving the sides in a little bit.
The board I used is by HiLetGo and measures ~25x48mm.
The board I used is by HiLetGo and measures ~25x48mm.
jwitting también publica en
13 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
