ESPHome Sensor case

A compact case for LD2140B, LD2410C or LD1115H human presence detection sensor with BH1750 light sensor and GY-BME280 Temperature/humidity/Air pressure sensor

A wemos D1 mini or S2 mini will be needed as the main board.

Features:
* Adjustable side to side human presence sensor
* Tiltable mount (M4 size), M3 bolt and nut for the joint
* Extremely compact ( just don't look inside after closing the case)
* Friction fit

Notes:
* Careful when putting in the S2 mini, the boot button is quite easy to accidentally bump off
* I use the vbus pin as the 5V power for the mmWave sensor or alternatively you can solder a thin enamel copper wire on the resistor left side
* Multi connections like i2c bus, 3.3V and ground can be connect together with a thin wire and then use the exist header pin to wire it, just make sure to insulate the solder.
* I used 10cm female jumper wires cut in half, the wireside are solder to the sensors and the connector to the board, this exclude the 5V connector, sinc