Thingiverse
Espresso Funnel
von tsi_software
7
Downloads
4
Likes
0
Makes
**WARNING!** With anything that comes in contact with food or consumables the responsibility is yours to ensure food safety. I do NOT accept responsibilities!
Do you make a mess when you make espresso drinks? I do. That’s why I made this espresso funnel. But I also wanted to experiment with curved sides in OpenSCAD to improve the aesthetics. This is what I came up with.
If you print it upside down you should not need any supports but you will want about a 3mm brim to help stick it to the print table.
Do you make a mess when you make espresso drinks? I do. That’s why I made this espresso funnel. But I also wanted to experiment with curved sides in OpenSCAD to improve the aesthetics. This is what I came up with.
If you print it upside down you should not need any supports but you will want about a 3mm brim to help stick it to the print table.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
