Estes Pathfinder (kit# 1997)

Here are all of the 3D models you'll need in order to build and fly the Estes Pathfinder kit (#1997). it was produced and sold from 1998 to 1990.

STL parts supplied:
1) Fin can #1a - Cruciform (This will slide over the BT-60 tubing.)
2) Fin can #1b - Tri-form (This will slide over the BT-60 tubing.)
3) 5.5 inch (139.7mm) length x BT-60 (OD) fin can 2a (cruciform) (Integrated tubing coupler.)
*Adjust airframe tubing length from 18 inches to 12.5 inches (317.5mm)*
4) 5.5 inch (139.7mm) length x BT-60 (OD) fin can 2b (tri-form) (Integrated tubing coupler.)
*Adjust airframe tubing length from 18 inches to 12.5 inches (317.5mm)*
5-6) Motor mount rings for 24mm motors that will fit inside fin can 2a and 2b.
*Estes BT-50 tubing will fit within these rings.*
7) Fin (if you want to print fins and use them on your rocket.)
8) Fin with TTW (through the wall) tab
9) Fin with TTW (through the wall) tab Version 2 with slot to accommodate motor mount ring.
10-11) BT-60 to BT-50 Moto