Thingiverse
eSun eBox Top Mount
von Guru_McDoc
40
Downloads
27
Likes
1
Makes
Top mount for eSun Filament Box. Fits at least on Ender 3 V2 and CR-6 SE.
You need 2 x flat socket head cap screw M5x12 & M5 T-slot nut to install the mount.
No support needed to print holder, just print it with face down.
I used infill destiny of 25% and Cubic Subdivision as infill pattern.
Printed with PLA successfully on Ender 3 and CR-6 SE - both fitted perfectly.
You need 2 x flat socket head cap screw M5x12 & M5 T-slot nut to install the mount.
No support needed to print holder, just print it with face down.
I used infill destiny of 25% and Cubic Subdivision as infill pattern.
Printed with PLA successfully on Ender 3 and CR-6 SE - both fitted perfectly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
