Thingiverse
etee Tracker 1/4" strap mount
von skyspnc
0
Downloads
1
Likes
0
Makes
Basic adapter to use eteeTrackers with the standard quarter inch (1/4") strap for full body.
Print the bottom plate sideways, else the clips may snap.
Tolerances are designed for injection molding, you may have a hard time if your printer is not very accurate.
Courtesy of TG0. https://eteexr.com/
Print the bottom plate sideways, else the clips may snap.
Tolerances are designed for injection molding, you may have a hard time if your printer is not very accurate.
Courtesy of TG0. https://eteexr.com/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
