Thingiverse
#eternaltransmitter
door Lehaiver
54
Downloads
124
Likes
0
Makes
Alteration of the transmitter (CGM system).
The transmitter has a limited lifetime (about 1 year), after it must be replaced. The cost of the new device, sometimes is "unaffordable" for most people with diabetes and their families.
Alteration it is an ability to use the transmitter for an unlimited time.
!!!ATTENTION!!!:
Сheck the remaining battery charge of transmitter, and if it is less than 2 volts, do not use this alteration!!! Otherwise, they may swell and cause damage the transmitter body!!! Is better to replace the internal batteries completely.
In this alteration is better to use CR2032. For proper charge from LiR2032, limiting element is needed to reduce charging voltage and amperage!!! Otherwise, internal battaries may swell and cause damage the transmitter body!!!.
iDO IT AT YOUR OWN RISK!
How to:
Part 1: fixture - https://youtu.be/p_qOKHxJRSs
Part 2: pads - https://youtu.be/-Ta06eBPvQ8
Part 3: holder - https://youtu.be/2WrytWZIp0I
Please give feedback )
The transmitter has a limited lifetime (about 1 year), after it must be replaced. The cost of the new device, sometimes is "unaffordable" for most people with diabetes and their families.
Alteration it is an ability to use the transmitter for an unlimited time.
!!!ATTENTION!!!:
Сheck the remaining battery charge of transmitter, and if it is less than 2 volts, do not use this alteration!!! Otherwise, they may swell and cause damage the transmitter body!!! Is better to replace the internal batteries completely.
In this alteration is better to use CR2032. For proper charge from LiR2032, limiting element is needed to reduce charging voltage and amperage!!! Otherwise, internal battaries may swell and cause damage the transmitter body!!!.
iDO IT AT YOUR OWN RISK!
How to:
Part 1: fixture - https://youtu.be/p_qOKHxJRSs
Part 2: pads - https://youtu.be/-Ta06eBPvQ8
Part 3: holder - https://youtu.be/2WrytWZIp0I
Please give feedback )
Lehaiver publiceert ook op
41 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!