Thingiverse
Ethernet cable Dressing Tool. 24 cable
von Prostifer
9
Downloads
2
Likes
0
Makes
I have designed this tool due, a professional asked me about a similar solution.
This tool should to help him, to attach easier the ethernet wire to the rack and tray.
Comments are wellcomed. I will not print the item because y don´t need it. Then if you detect a issue or an improvement, please write me.
The idea is to place the 24 cables in to the grooves, then slide one part to close the grooves and insert an screw and nut in to the 3 holes.
It should keep closed until you decide to open the system.
The design are two pieces, but to improve the fit it should be printed as one. There are 1 mm gap between pieces.
This tool should to help him, to attach easier the ethernet wire to the rack and tray.
Comments are wellcomed. I will not print the item because y don´t need it. Then if you detect a issue or an improvement, please write me.
The idea is to place the 24 cables in to the grooves, then slide one part to close the grooves and insert an screw and nut in to the 3 holes.
It should keep closed until you decide to open the system.
The design are two pieces, but to improve the fit it should be printed as one. There are 1 mm gap between pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
