Thingiverse
Ethernet cable label holder
by Old-Steve
2
Downloads
5
Likes
0
Makes
I designed this ethernet cable label holder for my IP cameras that are plugged into my POE switch.
They will slip on to the ethernet cable then slide up and over the end of the rj45 connector. This holds the label straight.
The label holder face measures 12X25mm’s. 12mm’s wide so it fits a DYMO label.
I put 4 on a common brim for easy printing. Trim apart post print.
It’s a very easy print but there are a lot of retractions
Printed in PLA, .2 layer, 25% infill
They will slip on to the ethernet cable then slide up and over the end of the rj45 connector. This holds the label straight.
The label holder face measures 12X25mm’s. 12mm’s wide so it fits a DYMO label.
I put 4 on a common brim for easy printing. Trim apart post print.
It’s a very easy print but there are a lot of retractions
Printed in PLA, .2 layer, 25% infill
Old-Steve also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
